Panda Sense¶
Specifications¶
| Sensor Module | AHT30 |
|---|---|
| Connection Interface | PH2.0 4-pin |
| Operating Voltage | 3.3V |
| Temperature Detection Range & Accuracy | -40℃ - 120℃, ±0.5℃ (10℃ - 60℃) |
| Humidity Detection Range & Accuracy | 0-100%RH, ±3% (within 20%RH - 80%RH) |
| Dimensions | 27.98 x 27.95 x 11mm |
| Connecting Cable Length | 800mm |
| Panda Touch Firmware Support | Version 1.0.6 or Later |
Dimensions¶
Interfaces¶
Indicator Light¶
Green Light: Indicates the device is powered on normally.
Installation Guide¶
Required Accessories:
Installation Steps:
Note: First attach the Panda Sense inside the machine and then arrange the connecting cable. The firmware for the Panda Touch should be version 1.0.6 or later.
1.Use a soldering iron to install heat-set inserts into the printed mounting bracket.
2.Then use the soldering iron to insert two additional heat-set inserts into the printed mounting bracket and secure the Panda Sense Dock using M3X5 button head cap screws.
3.Attach the printed mounting bracket with the Panda Sense Dock onto the Panda Touch USB Dock.
See the completed installation image below:
4.Plug the Panda Sense Touch to the reserved I2C port on the back of your Panda Touch.
5.Plug the connecting cable into the Panda Sense Dock connector. Once the Panda Touch is magnetically attached to the Panda Touch USB Dock, the Panda Sense will function as expected.
Monitor the Temperature and Humidity from Panda Touch
Printer Standby Interface
Printing Interface
Axis Movement Interface